Hantarex Polo 2 28 inch questions

[grantspain]

but my chassis are both 220v right? 

hantarex polo 1 are 220v only
hantarex polo 2/star/polostar are 85v-255v
hantarex mtc9000/900 are 120v (u.k version requires 220vac for degauss as extra wiring)

[njay]

on which chassis connector (the two greenies)  did you stick the vid cable coming from the monitor? the top one ?
thanks  

[grantspain]

on which chassis connector (the two greenies)  did you stick the vid cable coming from the monitor? the top one ?
thanks  

the one infront of the remote board

[njay]

Cool , ow yeah i see a lot of monitor pictures here and usually the suction cup is sucked tight to the tube
but i cannot seem to get it like this when i connected both chassis the pins griped the inside but the suction cup stood outwards like it was going to get lose

[grantspain]

Cool , ow yeah i see a lot of monitor pictures here and usually the suction cup is sucked tight to the tube
but i cannot seem to get it like this when i connected both chassis the pins griped the inside but the suction cup stood outwards like it was going to get lose

you must be doing it wrong

[njay]

yeah i know that is why i am asking to learn

what i do:

1. pull back the rubber section
2. put one pin in the hole on the tube
3. try to get the other pin in
4. let go of the rubber

it will stick on my tube i cannot remove it so the pins are stuck but the rubber is not flat on the tube

[grantspain]

push the rubber flat

[njay]

lol as easy as that eh?

is it a huge issue when the rubber is not flat on ?

[grantspain]

lol as easy as that eh?

is it a huge issue when the rubber is not flat on ?

yep as the ht will arc

[njay]

First off thanks for all the info i really learn a lot from this

second i just remember when i put the neck board on its a little of center when compared to the monitor tube but it fits, i am asking this because i see a lot of pictures from tubes here with the neckboard centered with the tube

[grantspain]

should be dead centre-check your pins are not bent or maybe its just your eyesight

[njay]

two are top bent slighty but like said earlier the neckboard fits

[grantspain]

two are top bent slighty but like said earlier the neckboard fits

don't worry then

[grantspain]

last chassis is all but repaired,just waiting for the correct flyback to turn up(company sent me a polo2 flyback)
runs with a polo 2 flyback but vertical scan is low and no brightness control

fix on this ticking chassis is flyback/possible leaky bu508a/change of a few leaky caps

[njay]

nice really amazing work
now i have two good chassis sweet