Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Coin Door Wiring  (Read 1090 times)

0 Members and 1 Guest are viewing this topic.

acevedor2

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 380
  • Last login:May 25, 2024, 08:21:24 pm
Coin Door Wiring
« on: December 01, 2008, 01:19:23 am »
I know there are a bunch of threads and I know how to get the coin 1/2 hooked up to the IPAC.  My question is, do I have to send the grounds from the coin mechs back to the ipac as well, or will they work fine just grounded to the cab.

In other words, can i just run the positives from the coin mechs back to their respective ipac ports and then run the grounds to the cab, or do I have to run both positiver and ground from each mech back to the ipac?

Thanks as always!
Cheers!
Dedicated - Working:
Asteroids Deluxe
Firefox
Galaxian
Pacman
Viruta Fighter 2
Zombie Raid
Pool Sharks - Pinball

Projects:
Pole Position
Pole Position 2

Thenasty

  • Trade Count: (+17)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 4420
  • Last login:Yesterday at 03:48:22 pm
    • Thenasty's Arcademania Horizontal/Vertical monitor setup.
Re: Coin Door Wiring
« Reply #1 on: December 01, 2008, 08:38:15 am »
just try it, its quicker than typing this respond, but I connected the nd to the IPAC.  ;)
Thenasty's Arcademania Horizontal/Vertical setup.
http://forum.arcadecontrols.com/index.php?topic=26696.0

Free VGA Breakout Cable
http://forum.arcadecontrols.com/index.php?topic=38228.0

Ultimate All in One Coin Mech write up (Make your own)
http://forum.arcadecontrols.com/index.php?topic=19200.0

Franco B

  • Trade Count: (+10)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 3766
  • Last login:February 15, 2024, 09:14:06 am
Re: Coin Door Wiring
« Reply #2 on: December 01, 2008, 08:55:50 am »
Just daisy chain the Common terminals (ground), wire them to the IPACs GND terminal and wire each NO (normally open) terminal to the IPACs input terminals (Player 1 coin, Player 2 coin etc)