U360 restrictor kit and standard dust guard.

[dfwpiper1]

Unless I'm missing something glaringly obvious, I assume these two cannot be used together? I suppose the dust guard could just float on top of the restrictor halves. But that would have to be above surface. And that would just be wrong...

I guess my ultimate question is how would one using the restrictor kit bezel the hole in the control panel. Seems like you'd have an exposed (somewhat) edge.

[kixfan]

Yes you use them together.   The restrictor plate goes under the cp in the u360 and the dust cover floats on top of the cp.   

[dfwpiper1]

Yeah I just checked it again. It's all flush with 3/4" wood panel. I was going to rout it to have a higher joystick but that would make the rp too high. Oh well I think I'm digging the joystick height now anyway! 

[kixfan]

I want to retract my first answer.   I now see Ultramarc makes a top mounted restrictor plate u360.   I have the original.

[dkersten]

the top mount restrictor itself sits above a 3/4" CP, so if you use the dust guard it will "float" a little, about 2-3mm above the CP.  I just left them off so I have easy access to the restrictors.