Author Topic: Any coin mechs (Read 1504 times)

Mark Thomas · « **on:** May 03, 2012, 05:09:36 pm »

Can anyone recall a fellow forum user who used to sell metal plates that enabled any coin to be used in a coin door? I think he was based in USA.

Vigo · « **Reply #1 on:** May 03, 2012, 05:21:59 pm »

CheffoJeffo · « **Reply #2 on:** May 03, 2012, 05:24:02 pm »

Mark Thomas · « **Reply #3 on:** May 03, 2012, 05:36:08 pm »

Great stuff guys many thanks

Dervacumen · « **Reply #4 on:** May 03, 2012, 05:41:10 pm »

I missed these. I'm glad you asked. But they're sold out again.

yotsuya · « **Reply #5 on:** May 03, 2012, 05:51:48 pm »

I hope he does another run. I own 4 of them and have been extremely happy with them.

Mark Thomas · « **Reply #6 on:** May 03, 2012, 05:52:14 pm »

Yes just noticed this, I'll send him an email and I'm sure if there is enough interest he will consider another run of these.

Nephasth · « **Reply #7 on:** May 03, 2012, 08:18:27 pm »

Any coin mech (quarter or token) can be modified in less than 5 minutes to accept any sized coin up to a little over .984" in diameter...

Thenasty · « **Reply #8 on:** May 04, 2012, 11:28:03 am »

Here is my write up years ago.. Making your own ALL In One Coin Mech.

http://forum.arcadecontrols.com/index.php?topic=19200.0


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news