Looks good! What kind of materials/paint did you use because I need to do something similar.
Well, the thing that makes it look better than my usual work is the legs which are from an old set of end tables.
They originally attached to a metal frame from the top, so the sides were free from any holes or markings.
They are tapered on two sides (tapers originally facing in on the end tables).
Other than that, it's just a sheet of furniture grade oak plywood and $7 worth of moulding to cover the edges of the plywood.
I had the guy at the store rip two 14" strips out of the sheet long ways. The larger leftover piece was then cut for the top. I usually use birch or maple plywood, but my floor are red oak and the interior doors I installed have a (fake) red oak grain pattern on them, so I figured I'd give it a try. Everything but the floor is painted, so it's not going to look like a cabin.
The stand is 21.75" tall and 5ft long. No other scrap wood I had laying around was used. One sheet (in addition to the legs and trim) was enough with a little bit to spare.
It was assembled using a kreg jig and kreg screws. This is one of those tools I wish I'd bought ten years ago.
The bottom shelf is only deep enough to hold the dvd/bluray cases plus the thickness of the moulding.
The big empty area behind there gives the power strip, wall warts, & a 5 port Ethernet switch a place to live.
For the paint, I used Valspar latex enamel in Satin Black. At Lowe's it's over by the spray paint above the canned rustoleum.
The grain still shows through when the light hits it. Not sure if going with satin was a good choice or not. It seems to pick up dust very easily.
I built a low shelving unit a couple years ago that I made a few mistakes on.
First, it was just under 11" deep to get an extra strip out of the sheet, but I never liked how far the plugs in the back of the stereo receiver stuck out. 14" worked out much better.
On that one I used black stain instead of paint because I wanted the woodgrain to show through. It looked like I'd used cheap watery dollar store spray paint that wouldn't cover. It didn't look like stain at all, just milky uneven paint.