Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: WTB: Small Part for Joysticks  (Read 854 times)

0 Members and 1 Guest are viewing this topic.

sc1103

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 332
  • Last login:December 11, 2020, 08:37:35 pm
  • ......
WTB: Small Part for Joysticks
« on: September 16, 2004, 07:24:01 pm »
I am interested if anyone has any joystick "skirts" larger than those that come standard on a Happs Super - I cut the CP Overlay holes to large, so whne you press up part of the hole can be seen.  Anyone with any they'd be willing to sell?

Thenasty

  • Trade Count: (+17)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 4420
  • Last login:Yesterday at 10:11:22 am
    • Thenasty's Arcademania Horizontal/Vertical monitor setup.
Re:WTB: Small Part for Joysticks
« Reply #1 on: September 16, 2004, 07:56:04 pm »
just make one. I did from a spare siding from the house or any plastic in that matter. Just get a hole cutter (2 size, one for center and outside diameter). First nalil the big piece of plastic you have to a 4x4 then cut the center leaving the DRILL hole in the 4x4 so when you cut the outside diameter, place the drill bit in the mark that it made from first cut so its centered, kabish ?

BTW if yours show the part of the hole, so will other parts will show the hole cause that piece is all the same size.
« Last Edit: September 16, 2004, 07:57:49 pm by Thenasty »
Thenasty's Arcademania Horizontal/Vertical setup.
http://forum.arcadecontrols.com/index.php?topic=26696.0

Free VGA Breakout Cable
http://forum.arcadecontrols.com/index.php?topic=38228.0

Ultimate All in One Coin Mech write up (Make your own)
http://forum.arcadecontrols.com/index.php?topic=19200.0

sc1103

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 332
  • Last login:December 11, 2020, 08:37:35 pm
  • ......
Re:WTB: Small Part for Joysticks
« Reply #2 on: September 16, 2004, 08:11:09 pm »
)Thanks I'll try that

BTW i have seen larger "skirts" - when I bought my junked cab the CPO actually had some glued down...these were much larger (shoulda kept them  :P)