UltraStik 360 is acting weird, is this a hardware or software issue?

[upper2bits]

Brand new, one works great one wont go fully to the right.    Is this normal, is there something wrong with it?

[Crono22]

Ya seems normal, I have the same problem with one of my ultrastiks. Its the magnet itself hitting the metal bracket. I dont use analog I have all the ultrastiks setup for 8way 4way etc. So a slight movement to UPR registers. Try moving the joystick very slowly and see if it will reach all the way.

[upper2bits]

Ya seems normal, I have the same problem with one of my ultrastiks. Its the magnet itself hitting the metal bracket. I dont use analog I have all the ultrastiks setup for 8way 4way etc. So a slight movement to UPR registers. Try moving the joystick very slowly and see if it will reach all the way.

I have mine set to 8way too and that's what I started looking into it. I was trying to play fighter games and I couldn't go diagonal so I started looking into it and switched my joysticks and the other one works fine.

[DashRendar]

There was a known issue with the little ring that goes around the stick.  Some people were getting little shavings coming off that which was causing the symptom you're describing.

I think Andy changed the materials to address that.  There's a number of threads on BYOAC about this.

Anyway, that might be what you're running into.

[syph007]

None of the four I've owned do that.  I'd ask Andy, he's pretty quick to respond to emails.

[Gray_Area]

This is an analog mode issue relative to the tracking of the magnet underneath, and where the shaft centers.