FINISHED - Here comes Peter Pepper - Burgertime Cabaret/Mini scratch build

[koolmoecraig]

Just stumbled upon this.

Great work man!

[hotman]

Some of the skills on this forum really are amazing! top notch job 

[Unstupid]

With his little brothers:

Nice looking lineup... But I have to ask... Are you a house full of little people?

[rockyrocket]

Excellent!, well done.

[shrunkenmaster]

WOW that was quick.. Great work ..That Marquee retainer looks rather large. Is that because you use a smaller marquee that fits between the top and bottom wood piece?

Also, I wonder if black T molding below the control panel may look better. Did you consider this?

A bit late to reply, but I replaced the retainer with some thinner material. The large one was all I had at the time. Also replaced the CP t-molding with black.

My Burgertime skills are still awful - this is a hard game to master!

[selfie]

I have always loved Burgertime, I've always sucked at it too. I have fond memories of it as the first game I played on our Intellivision.

I got most of the design work done to build a bartop BT machine but never did the work...

I put the extra button on the CP too but added a "Salt" shaker


Seeing this has me inspired to actually do something with my design

[THE POKER BRAT]

i see you got much praise for your work...and i do admit...         GREAT JOB...ok,....how much for BOTH of them??......

if you dont want to sell them.. then can you make me a star wars mini and ship it to me??...

[Felsir]

Very nice! Professional design!

Question regarding the t-molding: in the chef's hat there are some sharp corners- is that 1 continous stretch of t-molding or did your cut strips for each curve? The t-molding looks really well done!

[shrunkenmaster]

Very nice! Professional design!

Question regarding the t-molding: in the chef's hat there are some sharp corners- is that 1 continous stretch of t-molding or did your cut strips for each curve? The t-molding looks really well done!

Thanks my man! I didn't actually cut the t-molding. For the harder angles, I stripped away some of the plastic that would normally go into the slot, then scored the other side across the width. I then used some hot glue to keep it in place. Hasn't popped out of the groove yet, which is good!