Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Bottom mounting question  (Read 1388 times)

0 Members and 1 Guest are viewing this topic.

Haterot

  • Trade Count: (+1)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 107
  • Last login:November 09, 2012, 09:27:41 am
Bottom mounting question
« on: September 11, 2009, 04:42:36 pm »
I am going to bottom mount my U360 (on 5/8th plywood), anyone know how large a diameter hole I need for the shaft.  I am using the octaganol restrictos so the throw is limited by that. Any ideas? 
Logged
Empire had the better ending. I mean, Luke gets his hand cut off, finds out Vader's his father, Han gets frozen and taken away by Boba Fett. It ends on such a down note. I mean, that's what life is, a series of down endings. All Jedi had was a bunch of Muppets

drventure

  • Trade Count: (+2)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 4152
  • Last login:April 23, 2024, 06:53:06 pm
  • Laser Death Ray Bargain Bin! Make me an offer!
Re: Bottom mounting question
« Reply #1 on: September 11, 2009, 04:50:29 pm »
I used the same size hole as for standard happ buttons (I think it's a 1" hole?)

BUT I did route out about 1/4 inch on the bottom of 3/4" ply so the stick didn't sit so low.
Logged

Haterot

  • Trade Count: (+1)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 107
  • Last login:November 09, 2012, 09:27:41 am
Re: Bottom mounting question
« Reply #2 on: September 11, 2009, 04:57:59 pm »
Im going to route out about 2mm for the faceplate but that is all. Im not sure I wan a 28mm hole. I would have to route out the circle a bit and put a dustwasher in there to flush it out, otherwise the cpo could tear at the hole.
Logged
Empire had the better ending. I mean, Luke gets his hand cut off, finds out Vader's his father, Han gets frozen and taken away by Boba Fett. It ends on such a down note. I mean, that's what life is, a series of down endings. All Jedi had was a bunch of Muppets
Pages: [1]
  
Go Up
« previous next »