N64/PSX > USB Adapter - Extending Selector Switch

[Franco B]

I have a couple of N64/PSX > USB adapters that I wish to extend the switch on.

This is the switch in question.



I guess I could just desolder it and run wires from the new switch position to the PCB but I would like to buy a nicer switch to replace it with. Will the switch be single or double pole?

This is the switch I would like to 'replace' it with, its a sub minature DPDT slide switch, would it be suitable?



This is a picture of the underside of the PCB if it helps:



If I label the pins:

123
456

it only looks as if pins 3, 4 and 6 are connected, is that correct?