Best drill bit to install 1/4" Spinner shaft

[juggle50]

Hey Gang,

Did a search and found a range.  What is the ideal bit to use to install a spinner with a quarter inch shaft.

Thanks

Kevin

[mark shaker]

3/8" ... 1/2" ... It doesn't really matter, as long as the the shaft does not rub the CP ans the knob covers the hole.

   - M

[Necro]

Depends on the spinner.

For instance, the Oscar spinners (at least the vortex) requires a larger hole then other spinners because of the small clip on it.

What kind are you talking about?

[juggle50]

One with a 1/4" shaft.  I guess I'd like the hole to be as small as possible with out touching the spinner shaft.  I'm just not sure what the next size up from th 1/4" bit is.

[quarterback]

One with a 1/4" shaft.  I guess I'd like the hole to be as small as possible with out touching the spinner shaft.  I'm just not sure what the next size up from th 1/4" bit is.

5/16ths would probably work.  But, in the end, the hole and shaft are going to be under the top of the spinner, so it probably won't show anyway.

[juggle50]

Thanks man

Kevin