t-molding question

[Silverwind]

I have 5/8 plywood.. will be putting 1/8 lexan on top of that..

should I get 3/4" t-molding to cover the side of the wood and also the side of the lexan? or just get 5/8 t-molding to cover just the wood?

Thanks

[eightbit]

Its personal preference, they also make a offset t-molding so that you can still center the slot on your board but have it overlap the plexi.

[Silverwind]

Its personal preference, they also make a offset t-molding so that you can still center the slot on your board but have it overlap the plexi.

you use laminate and not lexan on your CP correct eightbit?

I was going to ask you which method you used.. but it probably does not apply to your setup

They have a wider variety of t-moulding available in the 3/4" size.. which is half the reason I'm curious..

I suppose it would look smoother if the edge of the lexan was covered... the control panel would have more of a "one piece" appearance..

[eightbit]

The control panel that came on my first cab was 3/4" wood with plexi. The t-molding only covered the wood. I replaced that control panel and covered the replacement with vinyl with no over lay and I am very happy with it.

My other cab I covered in vinyl and then covered with plexi but the plexi was more for a way to hold the monitor glass down, then it was to cover the CP. It did make it possible to add labels to a couple of the buttons.

[Elkor]

IMO  ....

you should go with the 3/4.  That's what I did and I am VERY happy with the results.

it looks like a single sheet, and nobody is the wiser

(and mine is actually a laminate of MDF, sheet steel, and lexan!)

if you go with the offset 3/4 that eightbit suggested the slot will be somewhat easier to cut..

my 2c

[Jakobud]

I have 5/8" mdf with plexiglass and my 5/8" t-molding looks and feels great.

Jakobud

[Silverwind]

I have 5/8" mdf with plexiglass and my 5/8" t-molding looks and feels great.

Jakobud

Do you have any pictures of that jakobud?

[Silverwind]

IMO  ....

you should go with the 3/4.  That's what I did and I am VERY happy with the results.

it looks like a single sheet, and nobody is the wiser

(and mine is actually a laminate of MDF, sheet steel, and lexan!)

if you go with the offset 3/4 that eightbit suggested the slot will be somewhat easier to cut..

my 2c

If I want to remove the lexan (say to change artwork) will the 3/4 t-molding get in the way if it covers the lexan edge?

also.. since it is covering lexan as well as the wood.. is there an increased probability that the t-moulding will be bent/pull off at the top?

[eightbit]

If I want to remove the lexan (say to change artwork) will the 3/4 t-molding get in the way if it covers the lexan edge?

also.. since it is covering lexan as well as the wood.. is there an increased probability that the t-moulding will be bent/pull off at the top?

Nope, it shouldn't get in the way and it shouldn't bend at the top any more than if you weren't using lexan.