Hello,
I'm trying to wire my controls (never done any wiring before).
I have the miniPac with the wiring harness, and I've run the wires according to the diagram. However, the diagram lists buttons 1-8 for each player and I'm only using 6 buttons for each player.
Also the diagram doesn't show any wires for pause or exit, or pinball flippers (all of which I have). So, I have four extra wires that could go to these four buttons. My question is, is it very hard to set these buttons to do these functions? I'm assuming the wiring diagram was following MAME standard layout.
You'll have to excuse me if this is any easy question. I don't have all the software set up yet and I haven't installed a pinball emu yet at all. I know a lot of software will let you alter the keys, but I'm not sure what keys the 7 and 8 buttons for each player are.
Hope this makes sense, any help is appreciated.
thanks!