Hi Rampy,
I just found one of the used cans. Mine is the same shape and design... yet it says electronic cleaner. Its probably the exact same stuff... but labled differently.
Hmmm... heres the contents: Proprietary Hydrocarbon Solvent, Carbon Dioxide CAS 124-38-9
Says on front:
--------------------
contains no cfc's or hcfc's
safe on most plastics
leaves no residue
cleans away dust, dirt, and oxides
cat no. 64-4327
--------------------
Rampy, try without the 3 in 1. I think you will find it much better that way. As oscar stated... the 3 in 1 will slow them down. Also, there really is no need for that oil, as the bearing carry almost no load, and are only spun at low speeds.
Application:
Hold bearing in fingers, and spray 'heavily' on one side. Let solution soak into the bearing cover for about 30 seconds.
2) Spin bearing with the solvent side still facing upwards. Spin it rapidly for about 15 seconds. (simular to a washing machine

3) Repeat the whole process for the SAME side. This will completely flush any remaining gunk out. (rinse cycle

4) Turn bearing over, and do the other side the same way.
Report progress on the board, so people will believe me

(with exception to Oscar

)