Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Hardware Interface for motorized After Burner 2 Cab  (Read 1368 times)

0 Members and 1 Guest are viewing this topic.

StefanBurger

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 67
  • Last login:July 30, 2025, 03:31:27 pm
  • I want to build my own arcade controls!
Hardware Interface for motorized After Burner 2 Cab
« on: November 15, 2020, 08:24:31 am »
Started ‚research‘ to interface into mame emulated aburner2 rom with reasonable first results. Due to limitations of the serial interface I will try a different approach based on Raspberries GPIO as next step.

Here is a short video about the actual status:
Logged

baritonomarchetto

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 822
  • Last login:August 18, 2025, 10:00:47 am
Re: Hardware Interface for motorized After Burner 2 Cab
« Reply #1 on: November 15, 2020, 01:35:04 pm »
Nice! Keep us updated
Logged

StefanBurger

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 67
  • Last login:July 30, 2025, 03:31:27 pm
  • I want to build my own arcade controls!
Re: Hardware Interface for motorized After Burner 2 Cab
« Reply #2 on: November 15, 2020, 05:08:06 pm »
Thanks, will definetly do so!
Logged
Pages: [1]
  
Go Up
« previous next »