Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: I-PAC2 Firmware Upgrade Mode - Which Pin?  (Read 1362 times)

0 Members and 1 Guest are viewing this topic.

pacboy

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 44
  • Last login:December 24, 2019, 09:18:52 am
I-PAC2 Firmware Upgrade Mode - Which Pin?
« on: October 13, 2018, 04:45:37 pm »
On the Ultimarc website, it shows how to put the I-pac2 into firmware upgrade mode using the "hard" method:

https://www.ultimarc.com/fwupgrade.html

The picture shows a wire connecting the pin on the lower left to the ground screw.  I have the newer version of the I-pac2 , which has been redesigned and now has two rows of 10 pins:

http://ultimarc.com/ipac1.html

Which pin on the new design should be connected to ground?

Thanks for any advice.
Logged

AndyWarne

  • Trade Count: (+18)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 1938
  • Last login:April 11, 2021, 03:37:09 am
    • Ultimarc
Re: I-PAC2 Firmware Upgrade Mode - Which Pin?
« Reply #1 on: October 13, 2018, 09:01:54 pm »
The newer boards dont have this "Hard" method. It should not be necessary.

If there is a problem upgrading firmware I can assist via email.

andy@ultimarc.com
Logged
Pages: [1]
  
Go Up
« previous next »