star wars 14 tooth gear

[tony.silveira]

anyone know where i can get one?

[northerngames]

what pitch and what is the inner shaft diameter?

[tony.silveira]

what pitch and what is the inner shaft diameter?

oh boy, not sure.  let me see what I can find out.

is this maybe something you can make?  3d printer maybe?

[northerngames]

no but it depends on how thick the shaft or the inner diamer is.

if it is a match you will not have to worry about it wearing again.

possible to post a pic of it so I can get an idea of how big it actually is.

[northerngames]

I think I got ya covered lol.

check out the robinson racing products hardend 32p 14t steel pinion gear looks like a 5mm shaft but a bushing could be used to fill the gap if needed.

these are the #1 rc pinions and handle tens of thousands of rpm and never wear so unless you use the force your good to go forever lol.

it may be a mod gear type pitch too though but rrp also sells them and there all over ebay for cheap.

the inner diameter hole is the main thing though.

[tony.silveira]

thanks man, i went ahead and ordered one, lets see if it'll fit!

I think I got ya covered lol.

check out the robinson racing products hardend 32p 14t steel pinion gear looks like a 5mm shaft but a bushing could be used to fill the gap if needed.

these are the #1 rc pinions and handle tens of thousands of rpm and never wear so unless you use the force your good to go forever lol.

it may be a mod gear type pitch too though but rrp also sells them and there all over ebay for cheap.

the inner diameter hole is the main thing though.

[northerngames]

if it is too big in the shaft hole a sleeve may be able to be used but I looked into it and it looks like what I mentioned prior and if so it will last you forever as long as there is proper gear mesh.

[tony.silveira]

yikes!  way to small.  here is a pic showing them side by side.  thanks for the assist though.  anyone know where i can get a star wars 14 tooth gear?

[northerngames]

yeah that was way off and too bad too becuase the rrp's last forever and would have solved that issue for SW owners.

bummer but was worth the shot I guess.

so it was not a total waste I would buy the rrp off you, I could use one for my current rc build.

[ChadTower]

You can't put just one metal gear in there with the plastic gears.  It'll kill the others.

[northerngames]

no metal on metal is worse same with 100,000 rpm rc's.

we run that on the motor and a plastic spur a metal spur with a metal pinion last a half pack at best and turned to powder.

this is just a free spinning gear with no high rpm torque either so it would be fine..