Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Trimming Game On Grafix Ultimate marquee?  (Read 1012 times)

0 Members and 1 Guest are viewing this topic.

BadMouth

  • Trade Count: (+6)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 9272
  • Last login:Today at 03:15:04 pm
  • ...
Trimming Game On Grafix Ultimate marquee?
« on: December 29, 2012, 12:04:51 pm »
Is the material Game On Grafix Ultimate non-adhesive marquee made out of easily trimmable?

They charge based on length.  My marquee is less than half the height they allow.
I could fit another marquee or instruction card below it for no extra cost.
 
Just want to make sure that the laminate doesn't cause any issues with cutting them apart.

WindDrake

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 271
  • Last login:December 03, 2020, 09:49:05 pm
  • Electrical Engineer
Re: Trimming Game On Grafix Ultimate marquee?
« Reply #1 on: December 29, 2012, 02:24:32 pm »
You can cut/trim them no problem. I had to trim the Marquee in my UAII and it cut just fine.