Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: How to wire a JAMMA coing button?  (Read 1331 times)

0 Members and 1 Guest are viewing this topic.

cwatson237

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 10
  • Last login:April 10, 2012, 11:32:22 pm
How to wire a JAMMA coing button?
« on: September 15, 2011, 03:17:27 am »
Can someone tell me if a JAMMA coin button wired to the CP needs to be a momentary contact switch or can it be wired to a regular "cherry" microswitch button? If so, how???

I can only seem to get a small momentary button to work and I would prefer to use a full sized green button!
Logged

Franco B

  • Trade Count: (+10)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 3766
  • Last login:February 15, 2024, 09:14:06 am
Re: How to wire a JAMMA coing button?
« Reply #1 on: September 15, 2011, 05:09:50 am »
A regular "cherry" microswitch is a momentary switch. Just make sure you are connecting the GND and coin input wires to the COM and NO (normally open) terminals of your microswitch.
Logged

mgb

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 3500
  • Last login:August 03, 2025, 07:25:14 pm
  • North East, US
Re: How to wire a JAMMA coing button?
« Reply #2 on: September 15, 2011, 07:46:30 am »
with a cherry switch, make sure you're wiring it to the proper points on the switch. If you look at the switch, you will see one terminal marked "COM", one terminal marked "N.O." and one terminal marked "N.C."
make sure to use the COM and N.O. terminals and it should work just as well as the other switch that you were able to make work.
Logged

cwatson237

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 10
  • Last login:April 10, 2012, 11:32:22 pm
Re: How to wire a JAMMA coing button?
« Reply #3 on: September 16, 2011, 02:49:47 am »
It must have been some issue with the ground wire...it works when I use a different ground wire? Not really sure why that is?
Logged
Pages: [1]
  
Go Up
« previous next »