Author Topic: Problems Disassembling a Sharp XM-1801N Monitor (Read 2224 times)

Boingo · « **on:** May 31, 2009, 06:21:29 pm »

I decided to finally getting around to recapping one of the XM-1801 monitors from out of my Nintendo Vs machine, but after extracting the brute and unscrewing every screw I can find, I still can't get it apart and remove the main board to start recapping. Most annoying is a group of green wires in the centre of the board. They seem to end in what look like plugs, but the plugs also appear to be firmly soldered to the board.

Is there anyone who is experienced with the XM-1801 who can give me some advice on what is going on?

qrz · « **Reply #1 on:** May 31, 2009, 11:04:01 pm »

could they have a release tab on the connector ?

this is typical of gnd connectors

qrz

Boingo · « **Reply #2 on:** June 01, 2009, 06:20:47 pm »

I was looking for some, but I didn't find any.

I will look again just in case.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: Problems Disassembling a Sharp XM-1801N Monitor (Read 2224 times)

Boingo

Problems Disassembling a Sharp XM-1801N Monitor

qrz

Re: Problems Disassembling a Sharp XM-1801N Monitor

Boingo

Re: Problems Disassembling a Sharp XM-1801N Monitor