Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: help me pickout a router bit  (Read 1965 times)

0 Members and 1 Guest are viewing this topic.

clickhea

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 418
  • Last login:August 09, 2019, 07:33:40 am
help me pickout a router bit
« on: May 16, 2009, 06:55:54 pm »
i combined 2 pieces of 3/4 mdf together (which in the end will appear to be 1 thick piece of wood)

anyway, iam looking for a nice bit to put a finishing edge on the piece.. any suggestions?
Logged

Encryptor

  • Trade Count: (+34)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 1287
  • Last login:December 21, 2023, 08:01:18 pm
Re: help me pickout a router bit
« Reply #1 on: May 17, 2009, 06:09:43 am »
If I'm understanding your post then it sounds like you need a flush trim bit. It has a bearing that rides on the edge while the blades cut to make the edges identical.


Encryptor
Logged

Chadwick

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 174
  • Last login:January 11, 2010, 03:23:34 pm
Re: help me pickout a router bit
« Reply #2 on: May 17, 2009, 07:52:52 pm »
3/4" + 3/4" = 1-1/2"

you want to profile the edge so it is something other than square correct?
Logged

Namco

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 623
  • Last login:March 03, 2025, 10:40:32 pm
  • Now addicted to Williams pins... all of them.
    • Freddo Mame Project
Re: help me pickout a router bit
« Reply #3 on: May 18, 2009, 09:18:21 pm »
If the two pieces are joined at a right angle, I'd say a nice 1/4" roundover would be nice.
Logged

Chadwick

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 174
  • Last login:January 11, 2010, 03:23:34 pm
Re: help me pickout a router bit
« Reply #4 on: May 19, 2009, 11:14:18 am »
Logged
Pages: [1]
  
Go Up
« previous next »