Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: 21" Pc monitor in 19" cab  (Read 1215 times)

0 Members and 1 Guest are viewing this topic.

Kubit

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 4
  • Last login:May 29, 2005, 03:29:26 pm
  • I want to build my own arcade controls!
21" Pc monitor in 19" cab
« on: February 22, 2005, 11:18:46 am »
I've got a silverline jamma cab that I had to take the original 19" arcade monitor out of. I want to maximise screen size and figure that a decased 21" PC monitor should be roughly the same size.

Has anyone managed to fit a 21" PC monitor in their jamma cab and get the back on ok? I'm guessing most 19" jamma cabs are roughly the same size.

Also, when decasing a PC monitor does the tube extend all the way back to the plastic casing? (In which case I can just measure the monitor cos it's the depth that seems most likely not to fit.)
Thanks

Nocturnaloner

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 212
  • Last login:May 05, 2016, 12:39:53 pm
  • AARRRRcade!
Re: 21" Pc monitor in 19" cab
« Reply #1 on: February 23, 2005, 12:59:44 pm »
I can't say what will fit in your cab, but I can say that almost all modern pc monitors have a metal cage that surrounds the tube, just under the plastic casing, and yes, the tube (or the electronics it's conected to) extends back all the way.

M3talhead

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 747
  • Last login:October 09, 2020, 07:35:12 pm
  • Dont let Donkey Kong use your toilet.......
Re: 21" Pc monitor in 19" cab
« Reply #2 on: February 23, 2005, 04:07:01 pm »
Speaking of the metal cage surrounding a monitor chassis, when I replaced the WG in my Gauntlet cab, I used a 21" NEC and had to leave the back of the cabinet open so I didnt crush the cage. It was a bit of a pain since the cab wouldnt butt up against the wall completely. It stuck out about 1-2 inches, but if I remember if I removed that cage, the chassis would be exposed. Not the best thing to have.
Signature tags are dumb.