Betson monitor and PC standby

[jsansoterra]

I have a MAME setup using a Betson monitor and ARCADEVGA card.

When the PC goes to sleep (due to inactivity) the Betson displays a rectangular box that says 'check signal' (or some such). Obviously this is due to the PC being asleep.

Is there a way to make this BOX disappear so that it does not burn into the screen?

Right now the best I can do is turn on a 'blank' screensaver.

Thanks 

[desmatic]

you need to modify you're power settings.  Disable turn off hard disks, and monitor, and all that jazz.  You don't want any of that stuff enabled in a cabinet.  Just use the screensaver supplied by your fe, or launch a game that has one.

[jsansoterra]

Desmatic,

Yes, that is what I'm doing. Basically, throwing up a 'blank' screensaver at 15 minutes of no activity.

I just thought it would be nicer to have the PC actually 'sleep' when not in use, but no biggie!

Thanks again for the help.

[Pac Threat]

jsansoterra,

What is your opinion and experience for the Betson?  I assume thats the 27" one that Im on the verge of getting.  I just got my arcadevga card in the mail.

I want to head to the pittsburgh betson soon.

[jsansoterra]

So far, the Betson monitor has been terrific. I did all the setup tweaking with my normal 'pc' video card and then switched to the ARCADEVGA card when it was finally installed in my cabinet.

BTW: I installed it into a SlikSik cabinet and it fit great. The bezel SlikStik sent with the cabinet fit the monitor as well.