How about this one? Is THIS an isolation transformer?

[Sarver Systems]

From what I can tell:

110VAC in (side marked 117V/PRI/0V)

110VAC out (side marked 117C/1A/0V)
18VAC out (side marked 9V/0V/9V) with a center tap for 9VAC if needed.

Am I correct?
Is 1A enough to power a monitor?

[ed12]

look's like a 1amp iso to me
with a 18v ct secondary also
so lower 2=117vac
upper 3 = 18vac ct,which wuld mean 9 on either side of the ct

ed

[Sarver Systems]

Is 1A going to be enough to power, say, a 27" monitor? It would only be used for testing, nothing permanent.

[ed12]

eh 50/50
just to plug in and run for a min or so u should be ok
but not for a normal ussage ie a day or 2

ed

[Sarver Systems]

I'd have it plugging in for 1/2 hour or so, enough to calibrate color, H-hold, etc...

[ed12]

ya i have ran them for a full shift 14hr's
then i un-plug them..
would not sujest u put it into a cab for day to day use,but to each there own

ed

[Sarver Systems]

Thanks ed, appreciate the info!

[pbj]

If you can refrain from touching the monitor while powered on, you don't need the isolation transformer.