Trimming sideart

[wcndave]

I am looking at getting some art done from gameongrafix or a UK based firm if I can find one.

i assume it comes rectangular, so how does one trim the edges to match the shape of the cab?

i can imagine using scissors could leave ragged edges, and a knife marks in the laminate.

any clues?

Thanks

Dave

[yaksplat]

Just glide a sharp blade around the perimiter of the cab once the vinyl is on.  It'll cut through it like butter.

[Le Chuck]

Two different techniques I've used. 

Apply art, trim it to a half inch overhang and wrap the excess along the edge and into the T-molding channel so that it gets held down by the T-molding once you install it.  Pros:  no corner peel.  Cons: Ginourmous PITA

Apply with T-molding already installed and insert a new blade between the T-molding and the side panel.  Gently pull your way along the cabinet for a nice neat trimmed edge. Pros: Easy-peasy.  Cons: Peeling can be an issue depending on print source (though I've never run into it)

[wcndave]

Hey that helps, but is the t moulding not glued on so there is no gap?

[PL1]

Check out 14 minutes into the video from this post from Rikitiki's Side Art Install 101 thread for his advice on the subject.


Scott

[t3design]

I did the thin blade between cab and tmolding and it worked like a charm. Be sure to keep the blade pressure against the cabinet.

[wcndave]

Thaks everybody