Fusion esacpe issue

[UncleMame]

I looked and didn't find any thread(I hope I didn't miss it).  Does anyone know if a CP button can be mapped to Fusion for the escape key ?  I haven't found that as an option in the config.  It maps the general control buttons, but not an escape (or save/restore state for that matter either).  Anyone know if this can be done ?

Thanks

[gonzo90017]

Not that I know of. You need to use Closemul.

[UncleMame]

Thanks,  I'll try it.

I never would have even known about Closemul(never saw this before) - I appreciate the tip!

[zorrobandito]

Closemul will work but Fusion will quit with escape when it is run fullscreen:

fusion.exe "[rompath]\[name].[romext]" -gen -fullscreen

[UncleMame]

Although the full screen helps to use the esc key(I already can do this) - What I was really looking for was a solution to allow a joystick button to do this - I'm going to investigate closemul

Thanks