T-Molding alternative for Bartop?

[Pitman]

Hi everyone,

Planning a bartop at the moment and following some plans that state 12mm MDF to use... problem is the t-molding I see on gremlin arcade supplies and elsewhere are all 3/4" so there would be quite a overlap over the 12mm sides that need covering that obviously wouldn't look too good.

Any ideas on an alternative.

[BobA]

http://ukt-molding.co.uk/

The 1/2" colours are:

White, Black, Dark blue, Dark red and Yellow.

All of which are all the same as the 3/4" of the matching named colour but in a 1/2" width.

[Pitman]

legend, thanks bob.

This site has 12.7mm yellow which is just what i need but.. is it just all for show or can you order anything?

[shrunkenmaster]

Jyet email him with what you want. His name is Dennis Hannah and is a trusted vendor. I've ordered many times and had no problems.

[Pitman]

Again thanks, this has seriously got my motivation back on track, might even make a 'project announcement'.