I have a Golden Tee Fore Complete green board. Brand new power supply and bypass cable. I have it all set up and wired up. I am using the Jamma converter "RGB to VGA HD-Converter. This high quality video converter auto-detects and up-converts your CGA, EGA, VGA, or YUV Component video to a higher selectable resolution VGA device."
So I was real careful in wiring this up and following the directions in the manual. Doing as much research as possible. This is my first time with arcade equipment. Here is where I stand. Power supply wiring harness I am getting 5.05 volts after adjusting the power supply adjustment nob. With in requirements for booting up according to manual. I power it up Status 1 LED solid green, Status 2 LED blinking green, and IDE Status LED comes on for a split second then goes out. Hard drive seems to be on and spinning.
So when I check the video output on my monitor I got the card interface and menu on and working but no signal. Tried auto scan, changing outputs, changing the card resolution and no signal. Board video card is hooked to converter card directly via VGA cable.
Bummed to say the very least. New hobby equals big bucks and lots of work and nothing to show for it so far. Waaaaaah! OK enough sobbing this bastard is going to work if I have to get a PHD in Electronication.
Got to finish this project another one is coming and one is waiting not to mention the other hobbies.