Need dimensions of Apache Blackhawk Push-Pull Spinner, please!

[jasonbar]

http://www.apachecontrols.com/store/index.php?main_page=popup_image&pID=3


Howdy-

I shipped off my Blackhawk spinner knob to a friend to see if he can laser engrave a design onto the small cap on the top.

I then realized that I could aso whip up some artwork to go around the upper conical face.  Since I don't have the spinner in hand at the moment, could somebody pretty please measure the following?

1 - diameter of the flat cicle on top
2 - diameter of the knurled large diameter

Thank you very much!
-Jason

[jasonbar]

FYI: Apache responded.

1 - diameter of the flat circle on top   = 0.765”
2 - diameter of the knurled large diameter  = 1.765”

Thanks,
-Jason

[jasonbar]

Aaaaaand, the results!

Check out my other anodized & engraved spinner knob & steering wheel hub too: http://s242.photobucket.com/albums/ff97/infernolab/Arcade%20Game/?start=all

Thanks,
-Jason