Saint if you see this you may as well move it over to the restore thread, guess thats what this is turning into

Got a few things done on this today. Yanked the old t-mold and noticed that there was a bit of swelling. The wood is pretty weak in a few spots. Going to try some glue and clamps to see if I can strengthen it up otherwise I'll just cut out and replace it.
Whoever repainted this did a piss poor job. Inside the bezel area is all peeling and flaking. I'm not sure how to remove this stuff. I scaped off all the loose stuff and rand a palm sander over it a little. I may try paint remover to see if that will make a better base coat for the yellow I plan to put back on it.
Also filled in a rather large gouge in the top near the vent. Not quite sure how the heck that got there, but an easy fix.