Author Topic: 44 pin edge connector, Which system uses it? (Read 1292 times)

Avinitlarge · « **on:** September 02, 2009, 05:20:51 pm »

I may have dropped a bit of a klanger. I sold my Shinobi PCB on ebay. It was sold with what I thought was a JAMMA adaptor. The person that bought it said its not a JAMMA connector. I never actually checked if it was a JAMMA or not. The connector has 44 pins, The end 4 pins on each end are GND and I dont know what the rest are as I butchered the wiring? Any Ideas what it was??

Kevin Mullins · « **Reply #1 on:** September 02, 2009, 05:52:42 pm »

So what you're describing is an adapter that goes from the 56 pin Shinobi TO a 44 pin wiring harness ?

Shinobi is 56 pin LIKE a JAMMA pinout...... but it is definitely NOT JAMMA.
http://www.crazykong.com/pins/Shinobi.pin.txt

Lots of older systems used a 44 pin edge connector, so without knowing the exact wiring pinout that was used it would be hard to say.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: 44 pin edge connector, Which system uses it? (Read 1292 times)

Avinitlarge

44 pin edge connector, Which system uses it?

Kevin Mullins

Re: 44 pin edje connector, Which system uses it?