WTB Robotron ball top not wico

[crashdmj]

I need four robotron ball top handles, not the wico ones. The handle should measure 4" from the bottom of the ball to the bottom of the shaft. Like the pic. I plan to swap them with the P360 shafts. The pic shows what the length should be.
PM if you have some to sell.
Derek

[Grasshopper]

I think your best bet would be the guy who sells replica stainless steel handles on Ebay - n2new@aol.com

They are admittedly fairly expensive but from what I've heard very good quality.

[crashdmj]

He's where I got them, but OSCAR says they are not the right size (however I gave him another pic to look at and perhaps they are the right ones, this is like a still-pending request)
Derek

[Grasshopper]

I'm pretty certain that the Ebay guy normally sells his handles in 4" Robotron lengths. If not them he does make handles in custom lengths to order.

Incidentally, you might want to check our this auction - http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=3231479986&category=13718

They look a little short to be genuine Robotron handles but for $2 (assuming the price doesn't go up) you can't go wrong.