Happ Competiton Shaft Dimensions?

[Franco B]

Does anyone have the dimensions of the Happ competition shaft?

I'm after the following lengths + the diameters of the shaft.



A: Distance from the end of the shaft to the start of the e-clip groove

B: Distance from the end of the shaft to the start of the 2nd e-clip groove (or 2nd shaft diameter)

C: Distance from the end of the shaft to the bottom of the bat.

D: Ignore, I know its 146mm

I'm not sure if the 2nd 'line' on the shaft is a second e-clip groove or a change in diameter.

IIRC, the black section below the bat is a sleeve. Is that correct?

If you could also tell me the dimensions of the diameters of the shaft, including the e-clip groove(s) that would also be great.

I doubt if anyone has this data to hand but if someone with a digital vernier etc has a comp stick that they could measure I would appreciate it. 

[kowal]

iL euro joystick

C-88mm
D-147mm
A-2mm
B-9mm

and E - 19mm (III groove)

competion
C-89mm
D-146mm
A-2mm
B-9mm
E-19,5mm

[Franco B]

Thank you kowal   

[kowal]

groove is 1mm

shaft on end fi=10mm
groove fi=7mm
shaft cover fi=14,5mm iL, competion 14,7mm
battop fi=32mm on iL and fi=31,5 on competion
fi is diameter

You need this dimensions for custom balltop?

[Franco B]

Yeah, I'm making some Comp shafts with an M6x1 thread for the Seimitsu ball tops.

[Grasshopper]

For future reference, the dimensions of all the Happ joysticks can be found on the manufacturer's website:

www.industrias-lorenzo.com