yea ive seen those. still have to replace the rest of the pins in the other connectors though.
anyways, it looks like this site has some housings:
http://www.greatplainselectronics.com/products.asp?cat=37&pg=1the ID numbers are molex ID's. i did find them on the molex site also.
still not sure if they are the same. thought the connectors in my machine had little slots that sat in grooves on the boards.
edit: just looked at connector a3-j5 on the driver board. it goes 0000 0000 0000 000 0000. each space is a little divider in the housing.
are these special housings or do the ones from molex have the same dividers?also, the pin seems to be playing fine now. its gotta be the pins dont it? i did a quick check for broken diodes/bad solder joints on the coils and didnt see anything.
edit2: i must be blind. right on the molex site, it says where the ribs are at.