Think I messed up when I installed one of my U360s (FIXED)

[Gehrig]

I was hurting for room, so I cut U360 mounting bracket.  Took about 1/8" off so I could mount it next to an 8-way.   Problem is, I think the magnet in the U360 is picking up the something in that 8-way. 

This is tough to explain.  So let me explain the position of the sticks. 

This is a SlikStik Fighter Control Panel.

I mounted a U360 to the Left of the Right 8-way.  The U360 is unable to get anywhere close to the bottom left hand corner in the joystick calibration.  By this I mean it goes from the left postion straight to the down position.  So, my problems seems to occur when the magnet is closest to my 8-way.

Am I way off of thinking this is my problem?  If this is my problem, can anything be done about it?   At this point moving the stick is not an option.

[crummy]

The U360 uses a magnet to figure out where the joystick is, right? I'm sure other metal could affect the magnet, and hence the joystick sensor.

I don't know the layout of the cpanel you're referring to, but I'd imagine the joysticks would have to be pretty close.

[Gehrig]

Sitting here thinking about it.  My best bet atm, is to just remove the U360 and plug it into my pc to see if there is any difference. 

[Gehrig]

It's working now.  Stupid me.  I hadn't gone through the process of giving each U360 a seperate ID.  After I did that, it worked fine.

Just another of example of an idiot not following directions.....