Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Calibrating LCD topgun with guncon2-driver?  (Read 876 times)

0 Members and 1 Guest are viewing this topic.

Carsten Carlos

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 579
  • Last login:June 28, 2014, 05:06:25 am
  • Projects: Centipede extended, Asteroids
    • Carlos' Centipede-extended
Calibrating LCD topgun with guncon2-driver?
« on: March 16, 2007, 06:07:38 pm »
Hey there,

Its really a pain getting this gun to work! With the original drivers, it doesn't install, at least with the guncon2-driver it goes well.

I just don't understand if there's a chance I can calibrate the gun with this driver? I can start calibrating mode by pressing A and B while aiming to the floor, but it won't accept calibration shoots in the corners where they should be! e.g. I can't make the shot at the top left directly on the LEDS.

How do you folks calibrate the gun with the guncon2-drivers?  :dunno