Control Panel Box Attaching the Top with Velcro?

[rdowdy95]

Hey guys I am going by the Project Arcade book, and I have attached my 3 inch 1inch wide scrap pieces to the top of my control panel.  I used wood glue and a screw in the middle.  Haven't done the finishing nails yet still looking for small 1/2" finishing nails.  Anyways...On the little scrap wood pieces I am attaching to the interior side pieces of the control panel box.  I figure I use some wood glue and let it dry but do I need to screw a screw into the side of the little wood pieces......also with the glue.  It would be like screwing a screw into some the side where you can see the plywood.

[rdowdy95]

Guys I posted this same topic in woodworking because no answer here.  I should of put it in woodworking to begin with.

Can a moderator go ahead and delete this topic, now since I have it in woodworking.  Thanks.

[fragasaurus]

I don't think anyone responded because it's hard to tell if it's a question or comment.  I read it three times because I'm interested in doing something similar but I swear I didn't get what it was asking.