Button sizes!?!

[AE35]

Hey all!

I usually use the Happ comp. buttons, but now I have some control panels
that have smaller holes, so they won't fit!

Does anyone know where I can get buttons where the 'neck' is a little
smaller(width)?

Thanks,

Nicholas

[shardian]

Is this what you are looking for? Refer to the schematic at the bottom for hole size.

http://www.happcontrols.com/pushbuttons/601200xx.htm

[AE35]

Well, I'd have to measure first...but it seems that they are only shorter!?

I hate too small holes!

[destructor]

Is this what you are looking for? Refer to the schematic at the bottom for hole size.

http://www.happcontrols.com/pushbuttons/601200xx.htm

Momentary Contact Pushbuttons looks as Sanwa 30mm. If these have the same size as Sanwa 30mm then are short ad width is bigger than Happ comp.

Your holes can be for Sanwa 24mm (24mm diameter) pushbuttons.
What is diameter your holes?

[shardian]

Competition pushbuttons have a 1-1/8" mounting hole. These call for  a 0.94 mounting hole.

[destructor]

Competition pushbuttons have a 1-1/8" mounting hole. These call for  a 0.94 mounting hole.

Yes, you are right, I didn't notice schematic

Then these are the same size as Sanwa 24mm.

[AE35]

Cool! I'll measure when I get home!!

Where can I buy them?? Hopefully not from Happ or too far away!
(I live in Copenhagen, Denmark)

Thanks!!

[destructor]

Germany:
http://www.project-firestorm.com/shop/catalog/index.php?cPath=76_96

Or Akihabara shop (directly from Japan).

[Aurich]

http://akihabarashop.com/products.html <- Excellent service, but for a small order you might be better off with that German link.