Horizontal width coil adjustment?

[Popcorrin]

1st question: I was wondering if someone knew where to get a horizontal width coil adjustment tool?

2nd question:  I have WG K7000 that I need to adjust the width on.  I was wondering if anyone had any advice when it comes to adjusting the width coil?  Do I have to worry about applying too much pressure and breaking the ferrite core on the coil.  Is there anything to look out for?

[FrizzleFried]

The easiest place to find a tool is over at Radio Shack.  They come in a set of 3 or 5 (i believe).  The 3-tool set contains the tool you are looking for...

[Popcorrin]

Anybody have any advice when it comes to adjusting it?

[grantspain]

when you get your PLASTIC trimming tool insert it in the width coil and turn which ever way you require to get your picture the correct size using a mirror to see what you are doing
you will not break the ferrite core with the correct tool

[Popcorrin]

Okay, thanks for the info.

[Ken Layton]

Visit here for more info:

www.homearcade.org/BBBB/wc.html

[Popcorrin]

Thanks for the link Ken.  I wish I would have read it sooner because
I tried adjusting the darn thing and it wouldn't budge.  I ended up busting the end off of the tool.    I'll have another go at it using the info off of that site. 

[Ken Layton]

Remember that sometimes the monitor manufacturer will glue the width coil adjustment in place at the time of manufacture. Sometimes you can soften the glue with the heat from a hair dryer enough to allow you to turn the coil slug. If not then you need to order a replacement width coil. The replacements are not glued and have no need to be glued.