I have a cab that i built and I was going to make a mame machine out of i, but I got off task and don't know if I want to take the cab approach anymore and I could use some money, I am In southeastern PA.
It is a 3/4 inch plywood cab with a monitor shelf with a slant...I am not sure of degree, maybe 12 degrees or something, it has a toe room slot on the bottom I didn't put a back on it because i figured it would be easier to make, get into, and it would be against a wall. It also has a bottom shelf and two more shelves inside, one high enough for acomputer, the front is strait, I wasn't planning on bulding in a cp, i was gonna make it seperate, so there is no slant for a cp. I put on one layer of primer white on it. It is sturdy, and I'll post up some pictures if anyone shows interrest, it is well made and the dimensions are:
79 inches high
28 inches wide
26 inches deep