Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Spinner bushing question  (Read 821 times)

0 Members and 1 Guest are viewing this topic.

ahofle

  • Trade Count: (+1)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 4544
  • Last login:August 30, 2023, 05:10:22 pm
    • Arcade Ambience Project
Spinner bushing question
« on: July 21, 2006, 11:29:32 am »
I recently decided to redo the vinyl control panel overlay under my lexan because you could see my carpentry imperfections (trackball mounting plate outlines and also a wrinkle here and there).  I used this thin rigid plastic sheeting and put the new overlay on it, and then the lexan over that.  It worked perfectly, however as thin as the sheeting is, I have slightly raised the height of the CP and as a result my Oscar spinner knob doesn't attach very well to the shaft anymore because there isn't much room on the shaft past the little white spacer/bushing thing where I can attach it with the set screw.  My question is...can I grind the little bushing down a little to give more room?  It seems very smooth on both ends and I wasn't sure if roughing up one end with sandpaper would change the spinning characteristics.  Any other suggestions? 

Thx,
Andy
« Last Edit: July 21, 2006, 11:34:54 am by ahofle »

fatfingers

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 966
  • Last login:April 17, 2025, 05:26:08 pm
  • Got UltraStiks?™
Re: Spinner bushing question
« Reply #1 on: July 21, 2006, 11:51:25 am »

Could you just route the bottom of the control panel a little so that the spinner will sit up a little higher?  Then you wouldn't risk damaging the spinner.
My DK low scores
-------------------
1) 180700
2) 165000
3) 162900
4) 162600
5) 158500


W.W.P.M.D.?                                       I'm here to help ... I just don't do it. ™