best way to cut t-molding...?

[fixedpigs]

what is the best way to get a straight cut on the end of t-molding...?

                                                                                     thanks...!

[Circo]

I just used a utility knife, had no problems whatsoever.

[javeryh]

I used a utility knife too and it came out fine (not 100% perfect but close enough).  There is a thread around here somewhere where someone used a pipe cutter to get the perfect cut...

[leapinlew]

I used scissors.

[somunny]

I have one of those cutters that places like Home Depot use to cut rubber/plastic tubing.  Perfect cut every time.

Steve

[Ken Layton]

I used a cutoff wheel in a Dremel tool.

[fixedpigs]

thanks for all of the suggestions...!