Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Groovygamegear Spinner Question **SOLVED**  (Read 1151 times)

0 Members and 1 Guest are viewing this topic.

oldskoolcade

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 81
  • Last login:March 26, 2021, 11:46:36 am
  • I'm a llama!
Groovygamegear Spinner Question **SOLVED**
« on: April 06, 2006, 08:13:49 pm »
Just got my spinner (yay Randy!)

Maybe I'm dumb (my wife seems to think so most times), but I can't figure out how to adjust the height of the shaft so I can make it fit my control panel.  On the site it says to loosen the set screw, but I don't know which that is or where.

Anybody with some info that could help a dumb guy out, would be appreciated!

Cheers!
Mike
« Last Edit: April 06, 2006, 10:57:18 pm by oldskoolcade »
Logged

Timoe

  • Trade Count: (+2)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 1662
  • Last login:July 14, 2009, 09:50:12 am
  • Team-Oh-tAy-Oh
    • Rattlin' Trash
Re: Groovygamegear Spinner Question (actually help)
« Reply #1 on: April 06, 2006, 10:37:26 pm »
here ya go!


you will need a small allen wrench to loosen this screw.  Then pull the shaft up to the height you need and retighten the set screw.  Be sure not to over tighten.
Logged

oldskoolcade

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 81
  • Last login:March 26, 2021, 11:46:36 am
  • I'm a llama!
Re: Groovygamegear Spinner Question (actually help)
« Reply #2 on: April 06, 2006, 10:56:17 pm »
Thanks dude!   The second I saw your post, I got an e-mail from Randy explaining the same thing  :D

As I said to him, I knew it was a simple solution...it's just that I'm a little slow today  :P


Cheers!
Mike
Logged
Pages: [1]
  
Go Up
« previous next »