SlikStik Tornado Spinner and Ultimarc Opti-Pac

[Santo8742]

Newbie here with an interface question.  I just purchased the Tornado Spinner from SlikStik with the new Mini-Pac/Opti-Pac interface cable and I need help hooking it up to the Opti-Pac.  The spinner has four cables connected at the end with a small red connector which I'm assuming is to connect it to the Min-Pac.  I'm guessing I have to cut off the connector and plug each wire into the corresponding spot on the Opti-Pac.  The problem I have is I don't know what the wires are.  The wires are black, yellow, green, and purple and I'm guessing one is ground, one is 5v, one is X1/Y1, and one is X2/Y2 can anyone tell me what wire is what?  Thanks for the help.

[Santo8742]

Does anyone have the answer to this?  I don't want to plug the wrong wires in the wrong spots, I think it probably wouldn't be good to plug a power wire into an axis slot.  Any help would be appreciated.

[Havok]

I'm more on the GGG side, but try e-mailing their tech support:

info@slikstik.com

[AndyWarne]

Hopefully this will help:

[Santo8742]

That picture was exactly what I needed.  The colors are Black: gnd, Yellow: X2, Purple: X1, and Green: 5v. Thanks Andy.