Author Topic: T-molding? (Read 809 times)

Q*Bert_OP · « **on:** May 28, 2005, 05:30:55 pm »

Wher can I get GOOD QUALITY(3'32) bits(dremmel or router) for making a groove for t-molding?

Thanks.

AlanS17 · « **Reply #1 on:** May 28, 2005, 05:35:50 pm »

I don't recommend a Dremel for cutting the groove. It's not sturdy enough from my experience.

Teknique · « **Reply #2 on:** May 28, 2005, 05:37:07 pm »

http://www.carbide.com/

plug in "slot cut" in the search- everything you need here....

Tek

AlanS17 · « **Reply #3 on:** May 28, 2005, 05:37:20 pm »

Q*Bert_OP · « **Reply #4 on:** May 28, 2005, 11:56:41 pm »

Thanks for all the help.

I've finally found th right router bit.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news