Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: IPac ten pin header  (Read 798 times)

0 Members and 1 Guest are viewing this topic.

namedos

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 263
  • Last login:July 16, 2025, 07:15:23 pm
IPac ten pin header
« on: May 11, 2005, 11:25:39 pm »
I know that Ultimarc sells a wiring harness that includes LED's but i was wondering if anyone just made their own?  If so, what did you use?  Thanks.

Tiger-Heli

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 5447
  • Last login:January 03, 2018, 02:19:23 pm
  • Ron Howard? . . . er, I mean . . . Run, Coward!!!
    • Tiger-Heli
Re: IPac ten pin header
« Reply #1 on: May 12, 2005, 07:28:30 am »
Five options -

1) if you have an old computer case lying around, you can use the wires that go to the mother board jumpers for HDD LED, RESET, PWR, etc.  You can also buy similar connectors from www.allelectronics.com.

2)  I think a CD-Rom audio cable will fit, but you might need to cut it down - Dremel.

3)  The motherboard USB headers are the same layout, so you could buy one of those adapters to add two rear USB ports to a motherboard.  You can swap wire locations as needed.

4)  You could use a HDD or FDD ribbon cable and Dremel off the unneeded connections.

5)  You could carefully solder wires directly to the header on the I-PAC.
It's not what you take when you leave this world behind you, it's what you leave behind you when you go. - R. Travis.
When all is said and done, generally much more is SAID than DONE.