My jukebox project has finally started

[rob1234]

If anyone has hacked this keypad this way, please post some pics. Having problems 

[allroy1975]

Here's what I'm doing.  It's not done yet, so I don't know if it's right or what..but...

Now I think I just need to figure out where all the grounds are and connect them and the wires to my KeyWiz and I'll be done.  I HOPE!

Sorry for the pic, it's from my phone....it's just easier than the memory card when I'm planning this post on my way out the door to work.

[allroy1975]

it works!
in case anyone's courious and doesn't feel like figuring out how to get to all the grounds (there are 4 of them scattered around the PCB, just tap into pins 5,6,7 & 8.

I just bent them so they're all close and put some soldier on all of them and stuck my Ground Wire in there.

easy. 

just make sure you don't cut THOSE leads. 

Allroy

[gonzo90017]

Hey bumble. What are the specs on your jukebox. I'm planning to build one pretty soon. I'm planning on using an old motherboard with SK Jukebox. 

[Bumblebounces]

Hi all-

Sorry for not replying sooner but I am vacationing in Hawaii and haven't had a lot of time to keep up with emails and posts.

[javeryh]

Damn this thing is sweet.  Nice job!

[squirrellydw]

Any chance I can get the dimensions?  I would like to make something similar and the dimensions would be a good starting point.

Thanks

[Bumblebounces]

This is the document I was working from when I built it.  I know that I deviated from it in a few places, construction wise, but the dimensions are spot on.  All stock except the oak trim pieces and back panel are 3/4" MDF. 

Good luck

Bumble

[squirrellydw]

thanks