Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: ipac 4 problem  (Read 755 times)

0 Members and 1 Guest are viewing this topic.

Thedude1987

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 6
  • Last login:May 07, 2005, 09:52:49 pm
ipac 4 problem
« on: May 07, 2005, 08:57:26 pm »
im using an ipaq 4 and most of the buttons work but only when sw6 is held down.  The buttons will not work unless this button is held.  The joysticks work, but not the buttons.  again the buttons only work when this button is pressed.  any ideas why i have to hold down this button in order for the others to work?  im super noob guys
Logged

Tiger-Heli

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 5447
  • Last login:January 03, 2018, 02:19:23 pm
  • Ron Howard? . . . er, I mean . . . Run, Coward!!!
    • Tiger-Heli
Re: ipac 4 problem
« Reply #1 on: May 07, 2005, 09:31:56 pm »
Any chance you have the microswitch connected to SW6 wired to the NC terminal instead of NO - it's USUALLY the middle and end terminals you wire between, but not always.

Double check all your wiring.
Logged
It's not what you take when you leave this world behind you, it's what you leave behind you when you go. - R. Travis.
When all is said and done, generally much more is SAID than DONE.
Pages: [1]
  
Go Up
« previous next »