Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Bezel question...  (Read 1035 times)

0 Members and 1 Guest are viewing this topic.

chrisindfw

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 262
  • Last login:May 09, 2020, 05:57:34 pm
  • I drank what?
Bezel question...
« on: May 03, 2005, 04:33:34 pm »
Ok I tried searching but no luck...

Does anyone have the dimensions of the happs 27" bezel? I need to know how much plastic there is on the outside of the opening.

Thanks!
Logged

Franco

  • Guest
  • Trade Count: (0)
Re: Bezel question...
« Reply #1 on: May 03, 2005, 06:49:52 pm »
I don't know the answer personally. If no one else can enlighten you you could always try emailing them.

info@happcontrols.com
Logged

NinjaEpisode

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 733
  • Last login:June 16, 2019, 06:47:45 pm
Re: Bezel question...
« Reply #2 on: May 03, 2005, 08:40:09 pm »
Bezel, uncut, is approximately 29 1/4 " Tall by 29 3/8" Wide, give or take an 1/8".

There's approximately 3" on each side of the bezel, and 5" on top and bottom.

Still got mine sitting in the basement, not quite ready to install it yet.
Logged
Pages: [1]
  
Go Up
« previous next »