Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Help installing Oscar V2 push spinner  (Read 798 times)

0 Members and 1 Guest are viewing this topic.

rgecko

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 107
  • Last login:July 20, 2025, 09:40:36 pm
  • makin' da 'cade
Help installing Oscar V2 push spinner
« on: April 17, 2005, 04:54:31 pm »
Ok so I have the spinner and my CP is 5/8

JODY

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 548
  • Last login:June 08, 2025, 11:26:01 pm
  • After a long delay...the arcade is underway!
Re: Help installing Oscar V2 push spinner
« Reply #1 on: April 17, 2005, 05:04:37 pm »
I don't have a V2, but do have some of Oscar's other spinners.  Based on how the shaft is installed in yours is there an extra groove in the shaft coming out the bottom of the spinner?  If so, you may pull the metal keepers and raise the shaft.  The weight and encoder wheel may have set screws to loosen and adjust too.

rgecko

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 107
  • Last login:July 20, 2025, 09:40:36 pm
  • makin' da 'cade
Re: Help installing Oscar V2 push spinner
« Reply #2 on: April 17, 2005, 06:49:59 pm »
figured it out. seems that you need to take off the little black ring on the bottom, as there is a lock there that holds the shaft in place... all seems good now.  thanks!